How to Install Gola Aluminum Profiles- Step-by-Step Guide

The Gola Aluminum Profile System offers a sleek and modern solution for creating kitchen and bathroom cabinetry. The profiles feature a unique ” gola ” or handle-less design, providing a clean and minimalist aesthetic. Installing Gola aluminum profiles requires precision and attention to detail, but with the right tools and instructions, it can be a manageable DIY project.

Material Preparation and Measurement

Before you begin, gather your materials and tools:

Gola aluminum profiles

Screws and washers

Drill

Measuring tape

Level

Pencil or marking tool

Measure and mark the desired position of the profiles on the cabinet doors or drawers. Use a level to ensure the profiles will be installed straight and evenly.

Profile Attachment

Attach the Gola profiles to the cabinet doors or drawers using the screws and washers provided. Drive the screws in firmly, but avoid overtightening. Check the alignment of the profiles regularly during the installation process.

Handle Installation

Once the profiles are securely attached, install the handles. The handles typically consist of a metal bar or strip that fits into the groove of the Gola profile. Insert the handles and secure them with the provided screws or clips.

Adjustment and Finalization

Check the alignment of the handles and profiles one last time. Make any necessary adjustments using a screwdriver or hex key. Clean the installed profiles with a soft cloth to remove any debris or fingerprints.

Additional Tips

Use a drill bit slightly smaller than the screw size for a secure fit.

Countersink the screw heads slightly below the surface of the profile for a clean look.

If you encounter any gaps or imperfections during installation, use a filler or adhesive to conceal them.

Allow sufficient time for the adhesive or filler to dry before using the cabinetry.

Troubleshooting

If the profiles are not aligned correctly: Check the measurements and adjust the positioning of the profiles as needed.

If the handles are loose: Tighten the screws or clips that secure the handles.

If the profiles are not flush with the cabinet surface: Countersink the screw heads further or use a filler to even out the surface.

If the profiles have gaps or imperfections: Fill the gaps with a suitable adhesive or filler and allow it to dry before using the cabinetry.